There are various possibilities of installing the membranes in the MBR system. We have decided on the most efficient – the dip-molded membranes. They are located directly in the waste water to be filtered (Bio-reactor). Oxygen is entered in the bioreactor through the aerator located at the base and leads to the decomposition of carbon-, nitrogen- and phosphorus compounds. The membrane surfaces are cleaned by the increased flow speed between the membrane plates.
The purified waste water flows from outside to inside through the membrane, where it is taken through the permeate main collector with a low pressure of approx. 0.1 bar. Bacteria, particles and virus are held back easily due to the small size of pores of just 0.05 µm.

We customize our MBR plants individually as per your requirements. A combination with other water systems e.g. ion exchangers, vacuum- or reverse osmosis units is possible and contributes towards the improvement of the entire water management concept. If the requirements as regards the existing waste water treatment plants increase, then an easy upgrading of the existing system is possible through MBR.

 MSTP1A-3MF

Our MBR plant meets all the currently valid official provisions (Alaska, USCG, MEPC 159 (55)).
As an alternative to MBR, we offer our world-wide clients an innovative bio-film procedure, which likewise meets the limit values of MEPC 159 (55).